• Floors of industrial factories, warehouses, garages, parking lots, ... places with high requirements for anti-wear, anti-dust generation for concrete surfaces. 
  

• Ready to use. Easy to apply.
• Improved chemical and abrasion resistance compared to untreated concrete. Anti- dust. Improves cleanability.
• Non-yellowing.
• Good penetration. Improve hardness. Solvent free.
•  Colourless and odourless. Do not change the floor’s color.
• Apply in both outdoor and indoor.
• Environmentally friendly.

Chemical content:	Modified co-polymer and mineral powders, additive
Appearance / Color	Viscous liquid/ transparent
Consumption:	20 ÷ 40 m2 /Lít (depending on the concrete status)
pH	11.0 ± 1.0
Special gravity: ​	1.25 ± 0.05 kg/l
VOC content:	0 g/l
Active content:	≥ 30 %
Dilution ratio :	1.0 liter BestHard SS150 : 1.0 liter clean water.
Abrasion Resistance:	25 ÷ 40% increase in abrasion resistance (depend on surface condition)
Permeability:	2.0 ÷ 7.0 mm (depend on surface condition)
Application temperature:	Minimum: + 10oC ( above dew point temperature of 5oC) Maximum: + 40oC Relative humidity ≤ 80%
Preserve:	In cool and dry places, at temperatures between 5°C and 30°C
Shelf – life:	24 months from date of production
Packaging:	25liters/can ; 210l/drum, 1000l/tank

 

Surface preparation:

• Surfaces must be sound, open textured, clean, free from frost, laitance, surface water, oils, grease, coatings, all loosely adhering particles and other surface contaminants.
• In order to allow the material to penetrate deeply, concrete should be dried to the appropriate moisture content (≤8%).
  

Placing:

• Use a roller or low pressure sprayer to evenly speard the material to the surface according to the appropriate rate (depending on the surface status). After about 30 minutes (when the material begins to gel), use a clean water jet
  to spray an appropriate amount of water just enough to re-disperse (with a brush or a scrubber) the remaining material on the surface.
  
• Once the surface begins to dry again, rinse with water jet and dry with a wet rag or vacuum cleaner.
• When there is a need to polish the surface, it is recommended to use BestSlick G85 polishing compound to increase the aesthetics of the concrete surface.
  

Cleaning:

• Clean all tools and application equipment with clean water immediately after placing and before the material hardens. 
  

•  Premixed, one component, so easy to use.
• High permeability, strong activity.
• Significant increase in hardness, wear resistance, dust resistance for concrete surfaces.
• Improve the ability to clean and prevent contamination of concrete surfaces.
• Colorless, odorless, does not change the color of the concrete surface. • Suitable for interior and exterior use.
• Non-toxic, environmentally friendly